350x swing arm on 86 200x

[4x4chevette]

I just put a 86 350x swingarm on my 86 200x... anyone else do this? It was farliey simpled used all the 350x parts... had to grinde a little on the frame, and a little on the arm ( so i didnt take to much of just one) and it slide right in, now ove got a bigger roudn axle, which will hopefulyl help to keep me from bending it, and a wider stance, maybe I wont tip so much now?

The best part is, i can adjust the chain.before some idiot had an 85 swingarm on and I couldnt adjust crap.

[250sx]

post pics! :cool:

[dads]

can you do me a favor while you have it apart. measure the center collars 85/86 . ID,OD, & length in mm for me? and any OME bearing numbers you can get off old or new bearings
thanks AL

[4x4chevette]

What do you need me to measure now? and the OME part numbers for the bushings can be found at
www.bikebandit.com as far as i know....

Gotta give me a chance to figure out exactly what you want... I aitn godo with technical names

[dads]

Bandit changed. they do not use ome numbers any more. Its their own numbers so parts do not cross. They change it a year a go.
The center collar ( or inner bearing race of the swing )
At bandit the part # is 55939-001
Honda # is 52141-KA2-000

If you can not mic it. I took mine to a shop and had them mic it for me. The 200x collar miced at ID 14mm, OD 20mm, length 193mm.
The OD miced at 19.30 because of the wear from the bearings that were rusty.