ANDEE look come see

[dads]

I just happen to be doing a swing arm.

http://userpages.Cheshire.net/~dads/pic2/105.jpg

the red lines piont to the seal surfaces. that all so clamp the collar between the bearings.

http://userpages.Cheshire.net/~dads/pic2/101.jpg

right side look.

http://userpages.Cheshire.net/~dads/pic2/102.jpg

left side. you can see how close the sprocket back plate is.

http://userpages.Cheshire.net/~dads/pic2/103.jpg

shis is with seals bearings and collar installed.

http://userpages.Cheshire.net/~dads/pic2/104.jpg

[andee]

the picture of the complete swingarm, that is focused on the left side and rear sprocket, where the sprocket backplate almost touches the dust seals on the rear of the swingarm, i have a gap now of 1/16 of an inch. i can't get it any closer, but it is much better than it was. thanx for all of your help guys. :hail: :headbang: :D :D

[dads]

:thumbsup: 1/16th is right. your good to go. :D