timing chain

[93toytruck]

i have a 83' 200x and i am trying to get off the crank damper so that i may put on a new chain. Does anyone have any advice?:headbang:

[Mr. Richard]

TOYMAN WELCOME TO THE BOARD!!! if you are talkin about a flywheel ,, i say best money spent is a flywheel puller ,,, worth every dime :D :D

[93toytruck]

like one that you can find at an auto part store or what? where can i find one?

[dads]

:lmao: @ Kasey


I think hes talking about the oil rotor on the end of the crank shaft. Every ones favorite. has three philip screws in the cover.

Quote
i have a 83' 200x and i am trying to get off the crank damper


READ this post may help

http://www.3wheeler.org/vb/showthread.php?s=&threadid=14685&highlight=Glenn

[hrc200x]

The swing arm bolt works as a flywheel puller on '83-'85 200x's. Take out the bolt that originally holds on the flywheel, then you'll see large threads in the flywheel its self, thread the swing arm bolt in those until it pops off. The front axle bolt might be the same threads, but I'm not positive.

[93toytruck]

its not the oil rotor on the right side of the engine, its on the left side of the motor. That big damper with the timing marks on it. how do you get that off?

[dads]

Timeing Rotor

Go to a parts store or home depot. get a grade 8 -14 mm bolt that takes a 22 mm wrench. put two blocks of wood under the piston to stop the crank. tighten the bolt , hit with hammer tighten some more hit again it will pop off.

[93toytruck]

thanks dudes. i got it off and hopefully we can all meet up at glamis and drink some beer.