Possiable 350x Clutch Problem???

[sugarkid_99]

When I try to go from anything over 1/2 throttle to full throttle all the bike seems to do is rev. But if I ease into the throttle it wont do it, but I really have to ease in to it. Is this the clutch slipping or even the clutch at all? Or something else???:wtf:

Thanks in advance!!!

[Howard]

sounds like a clutch to me, try to do some adjustments on it.
if not replace the clutch fibers.
http://www.3wheeler.org/tech/350Xownersmanual/Page50.html

look throught that book it will help you out. if you get ne wfibers soak them in oil for a while before install.
:thumbsup:

[sugarkid_99]

Thanks, Ill give it a try!!! Hopefully it works and I dont have to replace the clutch:shocked::mad:

[Howard]

they are easy to change out. :thumbsup:

[sugarkid_99]

Glad to know that its not a royal pain in the azz!:lala: I did a little adjusting tonight and it got a little better, but I didnt have much time to mess with it because it was getting to late to ride out here plus it was starting to rain :cry:
Thanks agian, Ill keep you updated!

[Mobular]

If you end up taking it apart to inspect, and find that the discs are ok, just replace the springs with some h/d units.

[ATCnut]

OK, time to get out an old trick. Take the clutch apart, and put washers under the springs. Its kinda like HD springs, but lots cheaper. It will not last a long time, but will last for a while.

[Mobular]

If you do the washer trick, make sure that you don't have spring bind under compression!

[ATCnut]

You are exactly correct mobular. Too much washer does not work either. In the day, I would use just one washer, usually that was all it took.

[sugarkid_99]

How much do the HD springs ushally run?

Thanks agian:headbang: ,
-Eric