200x with 200s auto conversion questions

[hrc200x]

My cousin just got done installing a auto 200s engine into a 200x, and there is only a few things left to be resolved.

Has anyone who has done this got the lights working? If so which wires did you hook up from the coils behind the left case?

What did you do for a brake peddle? Does anyone know the guy that used to make a brake peddle on ebay for this conversion?

Thanks

[short4stuff]

for the brake i read somewheres that the 200s will fit where the foot pegs bolt on or something .. then you just have to weld a piece to it, so it will connect to the master cylinder..

[350XXX]

Originally posted by short4stuff
for the brake i read somewheres that the 200s will fit where the foot pegs bolt on or something .. then you just have to weld a piece to it, so it will connect to the master cylinder..

not weld, bolt. you need a pic? if so PM me and i'll take you one with measurements.

[84200x]

I moved the parking brake cable to where the clutch cable goes on the perch. It was only temporary but it worked fine. If your parking brake doesn't work they are easy to adjust. I didn't get my light's to work though.

[84200x]

I just got done putting my 200s engine in another 200x. I did get the light's working. Yhe yellow wire plug's in just like the 200x and the green wire is a ground. Just ground it somewhere to the frame. I grounded mine on the top engine mount.

[350XXX]

here you go:D
the hole centers are 85MM or 3.350"(which is a little less than 3 3/8")

[350XXX]

another view;)

[350XXX]

you dont have to do any bending to the lever, its the same bends as stock.:rolleyes: