tecate (and maybe all 2strokes) question

[250sx]

on my t3 I can't launch at full throttle by popping the clutch. if I do the motor just bogs. if I feather the clutch it launches HARD, but if I pop it it damn near stalls. is this normal?

[dads]

Sounds like it's geared for top end not low end use. check the sprocket to see if changed.:D

[Mr. Kasey]

sounds like fuel delivery to me , what gear? my 250 launches hard in 1st ,2nd or 3rd from a dead start and i'm geared higher than stock ,,,,,

[250sx]

once I'm going I can use full throttle with no problem. it's just when I try and pop the clutch at full throttle from a stop that it bogs down. Am I supposed to have to feather the clutch? I was trying it on sand if that makes any difference.

[fishinmagician]

Yep, you got issues to work out, you should have had sand flying everywhere.

[Mr. Kasey]

hey dan, you have been into the carb did you look at the reeds are they new or old?,,,,, maybe a chipped corner

[macanic]

Hey heres your problem....

take that stock carb off and throw it as far as you can....
(its a beer can with a throttle valve.) junk...

go buy a 39mm keihn carb www.sudco.com
the best thing you can do
front sprocket 13t rear sprocket 42t
awsome hole shots!!!

then hold on to your bad motor scooter and ride!!!!

TECATE RULES!!!!