200X oil cooler

[haywood71]

Wasn't there a post on here a while back that showed how to put an oil cooler on a 200X, with where to drill your holes and such?

Jeff

[Rex Karz]

This might help.....: http://www.3wheeler.org/vb/showthread.php?s=&threadid=17197

[dads]

The only prob. is the oil flow. I wounder how much of a pressure drop to the lower end that cooler setup does.
If you need more oil to the top you drill out the orface in the top of the crank case oil passage way.
To do the oil cooler right you have to drill three hole in a line in the oil galley. one for oil out. one to plug the oil galley, one for oil return. that way the PSI does not change much.

[jenndnn3]

Haywood do a search over at 3ww.

Howdy shows how he set one up.

[350XXX]

well, i'm getting ready to split the cases on my 200 very soon and was wondering if i go ahead and tap the holes can i just plug the outside two also or do i need to run some hose between the two holes?

[200xjapan]

Here ya go!! (http://www.3wheelerworldforums.com/showthread.php?t=28433&highlight=200x+oil+cooler) I will be doing this mod will my X is getting rebuilt. I will be using the extra -8 line and AN that I have lying around along with an after market motorcycle oil cooler. I'll post pics after I am done.