Recoil questions with photographs.

[LonesomeTriZ]

--------------------------------------------------------------------------------

I am rebuilding the pull start on my YTM 200. I have ordered new parts and I am ready to reassemble it. My questions are as follows:

1. Is in necessary to use any kind of lubricants during the reassembly?

A. If so, what king?
B. What parts should be oiled or lubricated?

2. Will it hurt to paint certain parts to prevent them from rusting again?

3. Can some one find a simpler way to explain the method howdy has tried to describe in the past for recoiling the recoil spring?

4. Is there any thing else I should know about before I begin this reassembly?


Thanks for your assistance.

[mywifeknowseverythin]

Utah did a real nice rundown in the Tech Tips(at top of this forum:cool: ) for his 200s....

As for painting....I would just clean it up real good and be done with it....

http://www.3wheeler.org/vb/showthread.php?s=&threadid=14675

[LonesomeTriZ]

You are correct. That was some great advice.