200x has a built in flywheel puller

[hrc200x]

I hope this hasn't been posted in tech yet, but the '83-'85 200x's have a built in flywheel puller. If you need to get the flywheel off and don't have a puller remove the swing arm bolt and thread that into the flywheel. Use a wrench on the end of the bolt where the flat spot is to tighten it into the flywheel. Also, the front axle might work.

[short4stuff]

The front axle does work. But how do you stop the flywheel from turning?...

[jenndnn3]

I use an air on mine. I actually keep a spare 250r liquid pivot bolt for that purpose.