200X issues

[MoRaptor03]

I just had the cylinder bored, put new wiseco10.25:1 .20 over piston in. Now do I need to rejet? I also added a Uni Filter.. Ok now it seems that the new top end didnt help much. Its still smoking. Im guessing valve seal. But not sure. Am I on the right track her? Also how hard and expensive is it to install new valves,guides, seals whatever is all involved. Thanks All.

[firefirefire90]

Really, i would guess about 160 to do the whole valve job, 80 dollars for parts and 70-80 for labor.

[bman200x]

It usually costs about $35 for labor at my local shop, so look around for the best prices. You can get seals with any old top end gasket set. To replace the valves and springs is a little more expensive.

[MoRaptor03]

Im doing the work so I dont care about labor cost. Just parts and how hard it is.

[bones200x]

First of all. You will need a spring compressor. Very hard to put keepers in with out it...
If valves are worn, need to cut valve seats. Valve seals should be replaced when doing valves or rebuild in my opinion.