Front swing arm Bearings???

[ridetrikes250R]

how the heck do i get the bearings and dust caps off?? honestly i have no clue....got the pivot bolts out... but how about the rest??? book says to get it pressed out.... so.... how do i do this?
Adam

[dads]

If this is a 250r the dust cups should pull off. And the center collars should slide out too. Then you have two outter bushings that contain the bearings and two inners. these have to be reused unless you payed big bucks for new ones. You have ti drive them out with out messing them up.. Then you have to drive the bearing out of the bushings.

I sell the bearings for them. $5.50 each+ shipping

[ridetrikes250R]

check PM.... and ill try to pull the caps off......
Adam

[dunerash]

Dads is right.. You can try and take a socket and extention the same dia. as the hole and drive it out if you dont have a press. At least you got the pivot bolt out, that can be a b%&*h some times.. Mines apart now if you need any pics:doh:

[ridetrikes250R]

no i think i under stand... thanks guys!
Adam