PDA

View Full Version : 200s &200m


84200s/m
09-20-2002, 07:57 PM
what are some differences bettween the 2 and does any one have specs on these bikes
ATC_250SX
09-20-2002, 09:14 PM
i do belive the M has electric start and a high low gear box. and the s has a 5 speed with no extras.
Fuzzy
09-21-2002, 12:22 AM
I think the only difference was electric start. What specs do you need for it?.
Matt_200s
09-21-2002, 05:36 PM
I think it looked a lot different. They had bigger wheels and tires than the s. The m also had electric start and a slightly different frame to accomadate for the battery.
84200s/m
09-21-2002, 05:36 PM
valve specs and how do i tighten the timeing chain
ATC_250SX
09-21-2002, 08:41 PM
i used to have an 83? 200m chassis and motor and it had electric and high low. no reverse though.
Fuzzy
09-21-2002, 09:48 PM
Matt is right about the bigger tires. The 200m used 25" instead of the 22" the 200s used.


ATC_250SX you must of had a 83 200e the 200m never came with high/low range. And the first year for the 200m was in 84. And that year the bigred 200es had high/low and reverse. So it must of been a 83 200e bigred. Electric and high/low only.
84200s/m
09-22-2002, 07:51 AM
does anyone have a wireing diagram for a 200m if so please send it to me a j_r_gillespie@hotmail.com
ATC_250SX
09-22-2002, 05:10 PM
fuzzy you are right , i got my two motors i had confused i have a 125M and i had a 200e. thanx for veriffying the year onb the 200e though i always wondered what year that was.
84200s/m
09-22-2002, 05:37 PM
how do i adjust the timeing chain
Fuzzy
09-22-2002, 06:33 PM
N/P ATC_250SX

To adjust the timing chain is easy. There is a little bolt behind the cylinder on the top of the tranny on the shifter side with a rubber cap on it. Remove the rubber cap. Loosen the locknut on the bolt. Start up your motor and let it warm up for a few minutes. Then turn the bolt out a couple of turns. And let the motor keep on running like that for a minute or two. Then just turn the bolt back in until you feel it hit. Then retighten down the lock nut and put the rubber cap back on it. And thats it.


I will see if i cant round up a wire diagram for you.
84200s/m
09-22-2002, 06:36 PM
ok thanks fuzzy
jenndnn3
09-22-2002, 06:42 PM
Hey fuzzy could you tell me where my ADJUSTING BOlT is on my 200x timing chain.....I had to put the dam thing back on by hand. you know roll thru the chain. it took us 4 times to get it lined up..grrr
Fuzzy
09-22-2002, 06:49 PM
Jenn it is on the opisite side(kick starter side) on the back of the cylinder. Just like a 350x i beleive.
Unregistered
10-01-2002, 09:11 PM
I have a 1984 200s. A friend of mine used to have a 200m. If I remember correctly, he had electric start, and the frame was the same size as a Big Red, which he also had. My 200s has a smaller frame, I think it is the same as the 125, and no electric start.