swing arm bearings [Archive] - 3wheeler.org Message Board

fox_33

10-02-2002, 06:44 AM

I finally was able to get the swingarm shaft and bearings out of my 200x. Does anyone have a picture of how this is supposed to be put together. The previous owner removed the bearings and install homemade bushings. I want to make it original. The roller bearings are on order, but it seems to me that there must be thrust bearings or something to keep the swingarm from shifting side-to-side. Does anyone know?

jenndnn3

10-02-2002, 10:43 AM

The best way to tell if you have everything and how it goes is to use bikebandit.com or partsfish.com.....both have the fiche up on the bikes so that you can just order parts. But I never order from em I just use their fiches....or get a manual. good luck and welcome to the board.

ATC_250SX

10-03-2002, 10:01 AM

yup Partsfish.com is you best bet. i have to do that once in a while.

JxxxOxxxE

10-03-2002, 03:15 PM

wow...how in the hell did you get it out?