200x swingarms

[markb]

does anybody know for a fact if the 85 swingarm will bolt into the 86 chassis? i realize the carrier is different i'm interested in the pivot area bolting up.
thanks mark

[250rAL]

I doubt it very much. The '86 was completely different from the '85. It even has a square tube frame vs. round in the '85.

[ATCRYDER]

No it wont.

83-85 200x's are jsut that.......86/87 200x's are jsut that.

Thats the differance.

[jenndnn3]

Give me measurement numbers and I will measure for you....I have an extra swingarm that i can measure....

[jenndnn3]

ok an update......some measurements for ya...
Bolt flange on a 86 200x measures 8X16 (partsfish)
Pivot bolt is 14mm (round) I dont know how long
The actual Swingarm is 8 inches across-wide
The side measures at 1-3/4inches across
Dont forget you will need the washers and other goodies added in your final measurements..(the ones that go on the outside)
I hope this helps jen

[markb]

ok i get the following in approximate measurements:
7 3/8's across the pivot area without the spacers
7 1/8 from pivot c'line to shock link c'line
15.5 from pivot to axle c'line
5 3/4 width across carrier
after posting this i had a moment of clarity and realized my direction was wrong. but thanks for checking jen i'm sure most people would say a 350x shock couldn't go in also
mark:doh:

[jenndnn3]

no prob...I can get you those measurements too....

[dads]

Originally posted by 250rAL
I doubt it very much. The '86 was completely different from the '85. It even has a square tube frame vs. round in the '85.




Well 84-86 that the square tube swingtail . 80-83 was the round swingtail. But they are interchangable "if the bolts have the same OD. I ownly have the 83 apart right how so i cant check the bolts. but all other measurments ar the same. Same axle, same shock.http://adam.cheshire.net/~dads/pic/t.jpg