Carb problems help needed

[WaimakRydah]

My 85 ATC200S got drowned yesterday and now has carb problems i need a step by step guide of how to properley remove the carb and clean it as i have never done this before and dont wanna ruin the bike

[3wheelergod]

It's pretty easy, just pull the slide out the top, undo the bolts that hold the carb on the motor, undo the gas line. You should have it off in your hand now. Take the phillips screws out of the bottom and there you go. It probably has some water in it, and your motor may also! Make sure there is NO water or dirt in the carb and put it back on, It wouldn't hurt to blow everthing out with carb cleaner as well!:doh: Put it back on and ride!!!!!!!!!!!!!

[WaimakRydah]

ok my fuel has water and its a really weird blue colour at the moment and i drained all the oil which had water in it. Do u have any picture guides so im sure as to what im doing and how to re install it

[3wheelergod]

I dont have any picts, some one else may. It is really nothing though! It is just a few bolts and nuts! Drain everthing and check your air filter also! You can remember how it goes, it is easy!

[WaimakRydah]

thanx 4 the help do u know how i can quickly drain whats practically a full tank of water diluted fuel?

[3wheelergod]

Just take the hose off the tank and put a longer one on it that will reach a gas tank and turn your tank to reserve. I would put a little more gas in it and repeat a few times, or just take it off and drain it in a bucket or something! Water will go to the bottom cause it is heavier than gas.