needle jet set question...

[oneclick]

i bought a new needle jet set, my question is how do you remove
the small jet from inside the carb? this is the jet set i bought from
dratv...

http://us.st12.yimg.com/us.st.yimg.com/I/dratv_2020_28861708

the piece i am talking about is the 2nd piece from the right in the pic above.

OR, will the existing one work? use all pieces except that one? would it work?
if not... how to easily remove the old one?


Jason

[FlyingW]

Jason, that brass barrel is in with a very light interferrance fit so it should push out from the slide side, push down with a punch or something like that. It comes out easy. Slide side push toward the bowl.

[oneclick]

sounds good... i'll try that tomorrow.

I figured it was press-fitted in there or something, very good information to know. :)


Jason