250r Parts

[Corvairguy]

Hello again,

I need a few parts for my worn out 250r. Rubber mounts for the fuel tank, sprockets and chain, swing arm bearings, front wheel bearings, etc..... Are there any companies that sell misc parts for these things or am I headed to the dealer? I would like to get this ready to ride again but do not know of any parts people to get this type of stuff from.

Any help would be appreciated.

Thanks,
Corvairguy

[Mr. Richard]

i buy all bearings at a bearing house, you can get cheap chain there too,,,

[Dirtsquirt]

For the bearings/seals and chain/sprockets I would recommend Rocky Mountain ( http://www.rockymountainatv.com ) Thier prices on sprockets and chains are top notch ( under $50 for a good non o-ring chain and steel sprokets ) and the bearings are near bearing house prices with out the hassle of the bearing and seal ##'s.

The gas tank rubbers sound like a dealer only part. Find the part number from partsfish ( http://www.partsfish.com ) and then go over to Service Honda to order it ( http://www.servicehonda.com ) I say this because service honda usually give a good discount on OEM parts, just remember that they have a $8.00 shipping charge no matter how small your package is so make it worth your while and order what you may need in the future.

-Dirt

[Ronjon851]

Check out Dennin Kirk.They sell kits for your bike and shipping is free if over $100.So check out all you might need and call for a free catalog 18003289280.If it's under $100 shipping is $6

[Unregistered]

do you have the trike or four wheeler? I have most of the rubber mounts for the 4 wheeler, will let go cheap