oil pump tool

[wheel-E 200x]

do i have to buy a honda tool to take the oil pump off or is there an easy/cheap way i can make one myself?

[da_catt]

what kind of bike? On my 85 200x to take the oil pump rotor off i had to get a tool. It is the same tool u need to change the clutch. the honda tool is expensive, but u can get a aftermarket one. I think most hondas use the same clutch tool.

[200x_Basket]

i just got one for (clutch tool) for $13 at the local bike shop.

[Fuzzy]

If you are in a hurry and dont want to order one and wait for it to show up. You can take a old socket with the same out side diameter. And cut notches in it. The nuts are usally not that tight.

[da_catt]

yeah the nuts are not tight unless someone took it apart before and put them on too tight. Like on mine. I got the tool at a local shop, they had a few in stock.

[wheel-E 200x]

yeah im kinda in a hurry. i havent torn it apart yet because i wasnt sure on the tool. im changing the clutch in my 200x. what size is the socket i need around a 20mm or something? im just going off of the pic i see in my manual. im just gonna buy a set from the dollar store or something cheap like that.ill figure something out.

[dads]

you will need a impact driver also for the oil rotos cover screws.

[TriZer]

those oil screws suck. I ended up having to grind them off when the impact driver wasn't getting anywhere and drilling was going really really slow. It was my parts motor though, so it doesn't really matter. :lala: I just think that dude is funny haha