busted 250r case...hard to fix?

[250sx]

how bad does this look? fixable or will I have to find new cases (or use one of the spares if I have the right piece)? :doh:

http://www.3wheeler.org/mypics/250r/P1200014.JPG

http://www.3wheeler.org/mypics/250r/P1200015.JPG

[200x_Basket]

hard to tell in that pic. does it go into the case or just the mount? if it goes into the case you will have to split it and repair it. otherwise AIRLEAKS and burned pistons:shocked:

[250sx]

how do you tell the difference?

[Rocketman]

That hole is in the bolt boss, not a problem. Run it

[250sx]

won't it be bad to get mud & junk up in there?

[dunerash]

I dont see a crack?..if your talking bout the hole in the middle of the mount?..Thats ok just clearance for the pipe..or I hope because mine looks the same...err kinda:doh:

[Dirtsquirt]

Don't worry about it...

That happens because inpatient owners try to split the cases with screwdrivers.

[Ronjon851]

Mine looks exactly the same.I just figured that at one point i time before I had my bike someone ground down that part to allow clearance for an aftermarket pipe but now I'm starting to think that's how they came from the factory.If you want to settle your nerves over it just fill that area in with some grease 'cause grease never rusts.

[200x_Basket]

it is not cracked:D i looked at it today and the case is perfect all the way around. he just needs to put them together, it will be a couple years;)

[250sx]

Just waiting on you to cut me a better deal. ;) :p

[200x_Basket]

:lmao:
that is a lot of work. i will work my the hour if you match my current wage;) it would still be cheaper then cycle service.

i checked that car out and you cant hardly give them away. i do like it though :lmao:

kasey
what would you charge to assemble all those parts into a running trike? it needs the kicker gears and a bearing carrier + bearings + seals.

[250sx]

sheesh you hook a guy up with some deals & this his the treatment you get. :shrug: :thmbsdwn: :cry:

Since you'll be doing most of the work AT your CURRENT job where they'll be paying you top $$$ I figure you'll already be getting paid for that time so you should do the labor for free! :thumbsup:

[200x_Basket]

you may ALMOST be a lawyer but you CANT get that deal past me :lmao: i could have it running in a couple of days. i have extended swingarms, cr reed cage with boysen reeds, kicker gears, bearing carrier, the right tools for the job. LOL
all you have to do is come off of the $$$$ or the parts.

:lmao: or better yet i will instruct you on how to do it. i do have a manual you can use. it is the honda manual! very helpful.

[250sx]

hey I'll do it myself this weekend if you will sit there and walk me through it. I need to learn anyway. :D

[200x_Basket]

no problem, what does a lawyer charge for consulting? :eek:

[250sx]

:rolleyes:

[200x_Basket]

LOL. we will get it running. i may have my 89 250r quad by then. i am trying to get in touch with him now. i sold that crapmaro rear $1400 in my pocket:p