removing the rotor...

[olive123]

am removing the rotor from a 200e have the flywheel remover. Need to change the cam chain.
it is just a long screw basically. Do i just screw it in and the flywheel backs off?
I had it pretty tight and it doesnt budge. I tapped with a hammer and even put the pin through the end of the rod and stuck a long heave screwdriver through to hold then was hitting the end of the wrench with a hammer and it started to move VERY slow but i wasnt sure if i was stripping the threads so i backed off.
Seem right?

[Fuzzy]

They can be real stubborn if they have been on there for 20 years,. Usally once they start to move they come right off.

You did get the crown locking nut off first before using the puller didnt you?.

[olive123]

there was a gismo attached to the front with a bolt running through to the shaft that is removed. I am following clymers t the t