Making the 250sx utility sport in to a 250sx supper sport

[dads]

Making the 250sx utility sport in to a 250sx supper sport

This is a 200x front fork set up on a 250sx. In pic one you can see the new steering stop. I’m marking center so it will be on striate.
http://userpages.Cheshire.net/~dads/pic2/1.jpg


the steering stop is in place, sitting on a 3/16 th thick pease of gasket for clearance.
http://userpages.Cheshire.net/~dads/pic2/2.jpg


stop is tacked in place in three spots. On each side and in front center.
http://userpages.Cheshire.net/~dads/pic2/3.jpg


remove the cap nut loosen upper shock clamp, and tap it up off.
http://userpages.Cheshire.net/~dads/pic2/4.jpg

[dads]

now your at the adjusting nut.
http://userpages.Cheshire.net/~dads/pic2/5.jpg

I put a plastic bag under the head so I do not have to chase bearing all over the shop floor. I know I’m just lazy. The trike is on a crate so the tire is off the floor.
http://userpages.Cheshire.net/~dads/pic2/6.jpg

stop all welded on you can see what is left of the SX stop. Also I have to weld two peases of 1/8 th inch flat stock one to each side of the stop because the X has a little more turning raidios than the SX gas tank will allow.
http://userpages.Cheshire.net/~dads/pic2/7.jpg

This is the SX steering stop all removed.
http://userpages.Cheshire.net/~dads/pic2/8.jpg

[Fuzzy]

dads are there any mods to the stering stem to fit your frame? Or are the 250sx bearing for the stem the same size?.

[dads]

No Fuzzy the 200x and the SX are the same bearings

[Fuzzy]

Way cool that is a great mod for them. :headbang: