28mm carb for a 200x

[okieRrider]

hello, i just bought a 28 mm carb for my 200x and am wondering if it will benefit me putting it on with basically a stock engine, other than a cobra pipe and uni filter? it is flat slide mikuni carb. thanks, 200x driver

[200xman]

Where idi you get hte carb? I would be interested in one for my 200x.

[markb]

probably, never tried it do a search on this board
did any of you guys win that WB 28mm kit that was on ebay a week ago? it went for $194 which was a really good deal.
mark

[okieRrider]

i got the carb off ebay. it was good deal, so i thought i would try it.i got it for $30 and recieved it today and took it apart and cleaned it but need an intake for it.

[Fuzzy]

I would think it should make a difference. You allready have a after market pipe and a uni filter so it should be able to breath good.

But i would jet it down quite a bit. maybe get one of them 5 jet kits from DK and keep reading the plug until you find the right jet for your engine setup.

[REPOBUD]

IM KINDA IN THE SAME BOAT. I GOT THE INTAKE NOW I NEED THE CARB. :doh:

[markb]

as a note, if you buy a used 28 take a good look at the slide for wear cause a new one is $41. i just got mine so i can see what a 2.5 is like versus a 4. i'll post after i try it.
mark

[puttputt]

I need a carb for an 84 200M - if the X carb will work,
tell me what you want for it . . .

[okieRrider]

sorry but i'm goin to keep the old carb just in case i screw something up by trying to install this one, at least i could go back stock.