may have a fix for my ady

[BIG BAD RED]

i found the prob with my ody...the exiter coil is bad...luckly i got a old engine that is siezed and striped but low and behold there is the coil i need and it works...i just have to get it out and into my ody...need to pull engine and flywheel..dam but it will be worth it..i phoned 2 guys today for there 350x's and left msg's since they were both at work...i cant wait...get rid of this dam 4 wheeler

[BIG BAD RED]

is it absolutly needed to use a flywheel puller...i need to get the rotar off so i can get at the coils in the stator..i realy dont want to have to pull the engine which i will have to do to get a puller in there but will a few crobars work...anything to help would...help..

[84200s/m]

CROW BARS MAY KNOCK YOUR CRANK OUT OF BALLENCE:doh:

[BIG BAD RED]

ok i will wait for my puller..how bad does it put it out

[84200s/m]

it all depends on how hard you pry and how off center you are

a puller will pull stright off but prying will push it off side ways

[BIG BAD RED]

yah i borrowd a regualer 2 hooked puller and i think i messed the threads on my crank...i will use a tap and die and fix it..i am brining it into the shop tonight so...if my dad is off work soon enough

[BIG BAD RED]

the funny thing is that he said he got a new stator put in and then it just died like a month after....but the screws that hold the stator plate down are all stiped to h3ll and the rotar is all beat like they did use crobars

[dave h]

with penatrating oil that soaked in there and a regular 2 or 3 arm (harmonic or whatever) puller you should be able to get it off. make sure you use the middle rotator peice that comes with it so you dont bugger up the shaft.

heres a tip, while there is pressure on the flywheel and puller, lightly tap the center pusher screw or flywheel. this sets up vibration on the flywheel and shaft, which will work the liquid wrench in there and help it it pop off.

also remember to put assembly lube, anti seize, or something else that has graphite (because graphite wont breakdown or change viscosity with temp, like grease) in it to make it easy to get that wheel off again.

just some suggestions,
dave

[BIG BAD RED]

yah i think the shaft is bunked...like i said i have had it and am brining it in to my shop...too bad i am not workin yet..if i ge tthe job..wednsday at 10 i will be interviewd...yah

[yamaman]

but will a few crobars work.


i think i messed the threads on my crank

AND YOU WANNA BE A BIKE MECHANIC:eek:

[BIG BAD RED]

does lithium grease have graphite in it and from now on yamagirl dont even bother posting

[yamaman]

:D :lmao: :lmao: :lmao: :lmao:


from now on yamagirl dont even bother posting

from a 15 yr old,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,:rolleyes:

[BIG BAD RED]

when someone asks a question theyt expect a answere not someone else critisizing...